TECHNICAL ALERT #24 FOR ALL USERS OF TWO COOL® v3.1.1

It has been discovered that under most conditions a critical error will occur when trying to print the Entire Model from the Reports menu. This is true for all modes (wafer fab, assembly & packaging, etc.). In some cases, the report will still correctly print but TWO COOL® will shut down.

The current work around, should you experience this issue, is to use the Multi-Model Reporting function found under the Reports menu. Select the single model you wish to print and then use the Entire Model selection from the Multi-Model Reporting sub-menu. Once this has been done, you can use the normal Entire Model reporting function under the Reports menu for the remainder of your current session. Alternatively, you can save the model to Excel from the print preview screen and print the entire model directly from Excel.

This issue will be corrected in the 3.1.2 release of TWO COOL®.

Techalert24-0412

Back to Top

 

 

 

SITE MAP 1SITE MAP 2SITE MAP3

6200 Stoneridge Mall Road • 3rd Floor • Pleasanton, CA 94588 • Tel 925-399-6246 • Fax 925-396-6174
©1995-2015 Wright Williams & Kelly, Inc. • All Rights Reserved • Email: [email protected]